OXYSEPT 1 Soft Lens Disinfecting Solution| • | Only use the OXYSEPT lens case with a grey blue left lens basket indicated in the directions for use. |
| • | Do not use tablets that are irregular in appearance. |
| • | Do not take tablets internally. |
| • | Always add an OXYSEPT 2 Neutralising Tablet with Indicator to the OXYSEPT 1 Disinfecting Solution to complete the disinfection and neutralisation process. |
| 1. | Wash, rinse and dry hands before handling your lenses. |
| 2. | Remove cap containing lens baskets from the lens case and fill to the fill line with OXYSEPT 1 Disinfecting Solution. |
| 3. | Remove one lens at a time. |
| 4. | If a surfactant cleaner is included in the regimen, follow the instructions for cleaning and rinsing as directed on the labelling. |
| 5. | Place the lenses in the appropriate baskets of the OXYSEPT lens case. |
| 1. | Dispense one OXYSEPT 2 Neutralising Tablet with Indicator into the OXYSEPT lens case containing the OXYSEPT 1 Disinfecting Solution. |
| 2. | Immediately replace the lens holder in the lens case and tighten the cap. |
| 3. | Gently turn the lens case upside down, then right side up 3 consecutive times to wet the upper surfaces of the cup and the inside of the cap. |
| 4. | Make sure that the tablet is in the solution before allowing the lenses to disinfect. |
| 5. | Allow your lenses to soak overnight (or at least 6 hours.) The OXYSEPT 2 Neutralising Tablet with Indicator contains an indicator that will cause the solution to turn pink when the tablet has dissolved. The pink colour indicates only that the tablet has been added. The lenses must soak for a minimum of 6 hours for neutralisation. |
| 6. | Before removing the lenses from the lens case, turn the lens case upside down for 5 seconds to ensure full neutralisation of all residual disinfecting solution in the lens case, then return case to upright position prior to opening. |
| 7. | Then apply the lenses to your eyes, or rinse the lenses with sterile saline solution (not OXYSEPT 1 Disinfecting Solution) and apply them to your eyes. |
| 8. | Discard solution; rinse the entire lens case assembly with sterile rinsing solution. Do not use soap or detergent. Air dry. |
| 1. | Once a week, while wearing your lenses, fill the empty OXYSEPT lens case to the fill line with OXYSEPT 1 Soft Lens Disinfecting Solution (do not add an OXYSEPT 2 Neutralising Tablet with Indicator.) |
| 2. | Tighten the cap. |
| 3. | Turn the lens case upside-down. |
| 4. | Leave the lens case in this position until you are ready to remove and disinfect your lenses. |
| 5. | You may use the solution remaining in the lens case to disinfect your lenses because the OXYSEPT 2 Neutralising Tablet with Indicator has not yet been added. |
| 1. | On a daily basis, after adding the OXYSEPT 2 Neutralising Tablet with Indicator to the OXYSEPT 1 Disinfecting Solution, tighten the cap and gently invert the OXYSEPT Lens case 3 times to wet the upper surfaces of the lens case and inside of the cap. |
| 2. | Make sure that the tablet is still in the solution before allowing the lenses to disinfect. |
| • | Do not use OXYSEPT 2 Neutralising Tablet with Indicator if the foil barrier has been damaged prior to the day of use. |
| • | Keep out of reach of children. |
| • | Keep bottle tightly closed. |